Approved Document D — Toxic substances

ONLINE VERSION

The Building Regulations 2010 Toxic substances

APPROVED DOCUMENT

D1

Cavity insulation

D

For use in England* ONLINE VERSION

ditio 0n02, g 2 13 92 oreat ni d e n 20 nts 9 rp 0 a dm 1 co 01 en in 2 am

ONLINE VERSION MAIN CHANGES MADE BY THE 2010 AMENDMENTS The 2010 amendments reflect the changes made as a result of the Building Regulations 2010 and Building (Approved inspector etc) Regulations 2010. These were mainly regulation number changes as a result of re-ordering. There were no amendments to the substantive requirements in Schedule 1 (i.e. Parts A to P) of the Building Regulations. CHANGES MADE BY THE 2013 AMENDMENTS The changes, which apply only to England*, were to guidance on materials and workmanship. There were no changes to Part D of Schedule 1 to the Building Regulations 2010. *This approved document gives guidance for compliance with the Building Regulations for building work carried out in England. It also applies to building work carried out on excepted energy buildings in Wales as defined in the Welsh Ministers (Transfer of Functions) (No 2) Order 2009. ONLINE VERSION

ONLINE VERSION

D

Use of guidance

THE APPROVED DOCUMENTS The Building Regulations 2010 (SI 2010/2214), which came into operation on 1 October 2010, replace the Building Regulations 2000 (SI 2000/2531) and consolidate all subsequent revisions to those regulations. This document is one of a series that has been approved and issued by the Secretary of State for the purpose of providing practical guidance with respect to the requirements of Schedule 1 to and Regulation 7 of the Building Regulations 2010 for England and Wales. At the back of this document is a list of all the documents that have been approved and issued by the Secretary of State for this purpose. Approved Documents are intended to provide guidance for some of the more common building situations. However, there may well be alternative ways of achieving compliance with the requirements. Thus there is no obligation to adopt any particular solution contained in an Approved Document if you prefer to meet the relevant requirement in some other way. Other requirements The guidance contained in an Approved Document relates only to the particular requirements of the Regulations which the document addresses. The building work will also have to comply with the requirements of any other relevant paragraphs in Schedule 1 to the Regulations. There are Approved Documents which give guidance on each of the parts of Schedule 1 and on Regulation 7.

LIMITATION ON REQUIREMENTS In accordance with Regulation 8, the requirements in Part D of Schedule 1 to the Building Regulations do not require anything to be done except for the purpose of securing reasonable standards of health and safety for persons in or about buildings (and any others who may be affected by buildings or matters connected with buildings). MATERIALS AND WORKMANSHIP Any building work which is subject to the requirements imposed by Schedule 1 to the Building Regulations shall be carried out in accordance with regulation 7. Guidance on meeting these requirements on materials and workmanship is contained in Approved Document 7. Building Regulations are made for specific purposes, primarily the health and safety, welfare and convenience of people and for energy conservation. Standards and other technical specifications may provide relevant guidance to the extent that they relate to these considerations. However, they may also address other aspects of performance or matters which, although they relate to health and safety etc., are not covered by the Building Regulations. When an Approved Document makes reference to a named standard, the relevant version of the standard to which it refers is the one listed at the end of the publication. However, if this version has been revised or updated by the issuing standards body, the new version may be used as a source of guidance provided it continues to address the relevant requirements of the Regulations.

Approved Document D

ONLINE VERSION

Cavity insulation 1

D

USE OF GUIDAONCNE L I N E

THE WORKPLACE (HEALTH, SAFETY AND WELFARE) REGULATIONS 1992 The Workplace (Health, Safety and Welfare) Regulations 1992 contain some requirements which affect building design. The main requirements are now covered by the Building Regulations, but for further information see: Workplace health, safety and welfare. Workplace (Health, Safety and Welfare) Regulations 1992. Approved code of practice and guidance, 1998. HSE, L 24. ISBN 0 71760 413 6. The Workplace (Health, Safety and Welfare) Regulations 1992 apply to the common parts of flats and similar buildings if people such as cleaners and caretakers are employed to work in these common parts. Where the requirements of the Building Regulations that are covered by this part do not apply to dwellings, the provisions may still be required in the situations described above in order to satisfy the Workplace Regulations.

VERSION

Cavity insulation 2

ONLINE VERSION

Approved Document D

CAVITY INSULATIOON N L I N E V E R S I O N The Requirement This Approved Document deals with the following Requirement from Part D of Schedule 1 to the Building Regulations 2010.

Requirement Cavity insulation D1. If insulating material is inserted into a cavity in a cavity wall, reasonable precautions shall be taken to prevent the subsequent permeation of any toxic fumes from that material into any part of the building occupied by people.

Limits on application

D1

Approved Document D

ONLINE VERSION

Cavity insulation 3

D1

ONLINE VERSION

Acceptable level of performance

To reduce the risks to the health of persons in buildings formaldehyde fumes given off by urea formaldehyde foams should not penetrate to the occupied parts of buildings to an extent which would give rise to an irritant concentration.

Cavity insulation 4

ONLINE VERSION

Approved Document D

ONLINE VERSION Provisions meeting the performance Urea formaldehyde (UF) foam 1.1 Insulating materials which give off formaldehyde fumes (either when used or later in normal use) may be used to insulate the cavity in a cavity wall where there is a continuous barrier which will minimise as far as practicable the passage of fumes to the occupiable parts. Technical solution 1.2 A cavity wall may be insulated with UF foam where: a. the inner leaf of the wall is built of masonry (bricks or blocks); and b. the suitability of the wall for foam filling is assessed before the work is carried out in accordance with BS 8208-1:1985 Guide to assessment of suitability of external cavity walls for filling with thermal insulants. Existing traditional cavity construction; and c. the person carrying out the work holds (or operates under) a current Certificate of Registration of Assessed Capability for the work he is doing; and d. the material is in accordance with the relevant recommendations of BS 5617:1985 Specifications for urea formaldehyde (UF) foam systems suitable for thermal insulation of cavity walls with masonry or concrete inner and outer leaves; and e. the installation is in accordance with BS 5618:1985 Code of practice for thermal insulation of cavity walls (with masonry or concrete inner and outer leaves) by filling with urea formaldehyde (UF) foam systems.

D1

Approved Document D

ONLINE VERSION

Cavity insulation 5

D

ONLINE VERSION

Standards referred to

D1 BS 5617:1985 Specification for urea formaldehyde (UF) foam systems suitable for thermal insulation of cavity walls with masonry or concrete inner and outer leaves. BS 5618:1985 Code of practice for thermal insulation of cavity walls (with masonry or concrete inner and outer leaves) by filling with urea formaldehyde (UF) foam systems. AMD 6262 1990, AMD 7114 1992. BS 8208-1:1985 Guide to assessment of suitability of external cavity walls for filling with thermal insulants. Existing traditional cavity construction. AMD 4996 1985.

Cavity insulation 6

ONLINE VERSION

Approved Document D

ONLINE VERSION LIST OF APPROVED DOCUMENTS The following documents have been published to give guidance on how to meet the Building Regulations. You can find the date of the edition approved by the Secretary of State at www.gov.uk. Approved Document A Structure Approved Document B Fire safety Volume 1: Dwellinghouses Volume 2: Buildings other than dwellinghouses Approved Document C Site preparation and resistance to contaminants and moisture Approved Document D Toxic substances Approved Document E Resistance to the passage of sound Approved Document F Ventilation Approved Document G Sanitation, hot water safety and water efficiency Approved Document H Drainage and waste disposal Approved Document J Combustion appliances and fuel storage systems Approved Document K Protection from falling, collision and impact Approved Document L1A Conservation of fuel and power in new dwellings Approved Document L1B Conservation of fuel and power in existing dwellings Approved Document L2A Conservation of fuel and power in new buildings other than dwellings Approved Document L2B Conservation of fuel and power in existing buildings other than dwellings Approved Document M Access to and use of buildings Volume 1: Dwellings Volume 2: Buildings other than dwellings Approved Document P Electrical Safety – Dwellings Approved Document Q Security – Dwellings Approved Document 7 Materials and workmanship ONLINE VERSION

ONLINE VERSION Published by NBS, part of RIBA Enterprises Ltd, and available to purchase from: RIBA Bookshops Mail Order The Old Post Office, St Nicholas Street Newcastle Upon Tyne, NE1 1RH Telephone orders/General enquiries: +44 (0)191 244 5557 Email orders: sales@ribabookshops.com Or order online at: www.ribabookshops.com

ISBN 978 1 85946 678 0 Stock code 86884 © Crown Copyright, 2015 Reprint October 2015 incorporating 2002, 2010 and 2013 amendments You may re-use this information (excluding logos) free of charge in any format or medium, under the terms of the Open Government Licence v3. To view this licence, visit www.nationalarchives.gov.uk/doc/open-governmentlicence/version/3/ or write to the Information Policy Team, The National Archives, Kew, London TW9 4DU, or email psi@nationalarchives.gsi.gov.uk. Where we have identified any third-party copyright information, you will need to obtain permission from the copyright holders concerned. This publication is available for download at www.gov.uk. Copyright in the typographical arrangement, excluding logos, of the cover and the internal page layouts of this publication rests with the Publisher. Cert no. TT-COC-002168 ONLINE VERSION

www.thenbs.com